|
 On Time RTOS-32 Documentation
 Welcome
 RTTarget-32
RTTarget-32 Programming Manual
 Introduction
Running Win32 Programs without Win32
The i386 Microprocessor
RTLoc: Locating a Program
Running a Program on the Target
Cross Debugging
Using an IDE
The RTTarget-32 API
Demo Programs
 Running Demos with Command Line Tools
Running Demos in Microsoft Visual Studio
Running Demos in the Borland Delphi IDE
Using a Standard PC as a Target
Using a Standard PC as a Target for GUI Demos
Using the AMD Élan SC400 Evaluation Board
Using the AMD Élan SC520 Evaluation Board
Using the RTOS32Win Virtual Target
Using the Real-Time Hypervisor Target
Program Hello
Program Hello2
Program SerInt
Program SerDemo
Program EmuDemo
Program DLLDemo
Program DLLDemo2
Program DLLDemo3
Program SysDemo
Program FTPLoader
Program BIOSDemo
Program PCCard
Program PCCardMT
Program VMemDemo
Program FMapDemo
Program ExLED
Program HelloSc400
Program HelloSc520
Program NSHello
Program TVDemo
Program MetWorld
Program HelloGUI
Program HelloDelphi
Program BenchDelphi
Program MPDiag
Program Hellovmf
Program Vmftcp
Program Hellorth
Program Rthtcp
Program Msvccrt
Program ACPICADemo
Advanced Topics
Compiling and Linking with On Time RTOS-32
Redistributable Components of RTTarget-32
RTLoc Error Messages
RTTarget-32 Reference Manual
RTKernel-32
RTFiles-32
RTIP-32
RTPEG-32
RTUSB-32
|
Using the AMD Élan SC520 Evaluation Board
If you intend to use the Élan SC520 Evaluation Board, you must first install the Debug Monitor on the board using the following steps:
- Build the demo program HelloSc520.
- Program MonSc520.hex into a 256k EPROM and place it in the BIOS DIP socket.
- Configure the board to connect ROMCS0 to the BIOS DIP socket (this is the default).
- Use COM2 of the Evaluation Board to connect to the host (the lower right hand 9-pin connector). COM1 is configured to be RS422 by default and is therefore not suitable for communication with a RS232 port of the host.
 Demo Programs
 Using the AMD Élan SC400 Evaluation Board
 Using the RTOS32Win Virtual Target
|
